Microstructure and Mechanical Properties of Al-10Zn-4.5Mg-xCu Turbine Impeller Produced by Investment Casting
Keywords:
investment casting, aluminum alloys, turbine impeller, organic rankine cycleAbstract
Aluminium alloy can be applied for a turbine impeller of Organic Rankine Cycle power plant that operates at temperatures below 150 oC. Aluminum turbine impeller can enhance efficiency of turbine due to light weight material. Al alloys was used for impeller due to good mechanical properties. Turbine impeller commonly produced by machining but which is time-consuming and less efficient because of material removal. . It can be replace by Investment casting to produce impeller turbine due to their complex geometry and precision. This study identifies effect Cu content of Al-9Zn-4Mg-xCu on the microstructure and mechanical properties of turbine impeller produce by investment casting. The study also identifies casting defect of turbine impeller. The structures consisted of α-Al, MgZn2, CuMgAl2 and CuAl2. Higher Cu content is the higher hardness value due to CuAl2 phase. Visual examination showed that the turbine impeller was free of macro defects and misruns
References
[1] Jones, S. and Yuan, C., Advances in shell moulding for investment casting, J. Mat. Proc. Tech., Vol. 135, 2003, pp. 258–265.
[2] Lia, D. Z., Campbell, J., Li, Y. Y., Filling system for investment cast Ni-base turbine blades, J. Mat. Proc. Tech., Vol. 148, 2004, pp. 310–316.
[3] Gunasegaram, D. R., Farnsworth, D. J., Nguyen, T. T., Identification of critical factors affecting shrinkage porosity in permanent mold casting using numerical simulations based on design of experiments, J. Mat. Proc. Tech., Vol. 209, pp.1209-1219
[4] Jovanovic, M.T, Dimcic, B., Bobic, I., Zec, S., Maksimovic, V., Microstructure and mechanical properties of precision cast TiAl turbocharger, J. Mat. Proc. Tech., Vol. 167, 2005, pp.14-21
[5] Furukawa-Sky Aluminum Corporation Chiyoda-Ku Tokyo (Jp), Cast Aluminum Alloy Compressor Wheel For A Turbocharger, European Patent Application, 2005
[6] Wallace.G, Jackson.A.P, Midson. S. P. and Zhu.Q, “High-Quality Aluminum Turbocharger Impellers Produced By Thixocasting “, Trans.Nonferrous Met.Soc.China, vol 20, 2010, pp 1786 – 1791
[7] Muhammad Syahid, Bondan T.Sofyan, Singgih Giri Basuki, Bayu Adam, “Characterization of Al-7Si-Mg-Cu Alloy Radial Inflow Turbine Blade produced by Investment Casting, Advances Material Research, vol.789, 2013, pp 324-329
[8] Zang jin-xin, Zhang kun, Dai Sheng-long, Precipitation behavior and properties of a new high strength Al-Zn-Mg Cu alloy, Tran. Nonferrous Met. Soc. China, Vol. 22, 2012, pp. 2638-2644
